FILLING PANEL FOR COMPRESSOR
It has two gauges (one for each pressure) for controlling the load pressure. With its internal pressure regulator, you have the ability to offer dual pressure load (2 outputs and 2 outputs 300 bar to 225 bar).
BASIC DIR HARNESS
FILLING PANEL FOR COMPRESSOR WITH CAMS
Panel loading with 4 exits for connection to any compressor Coltri range. It has manometer to control the load pressure. Combined with a bank of air, it can be an ideal place for a bottle loading station configuration.
ELITE 2 HARNESS
SOLO HARNESS
MOLECULAR SIEVE
SHOULDER-PADS (Pair)
Comfortable shoulder pads. Material:Cordura 1100, polyethylene foam. Weight: 0,05 kg
ACTIVATED CARBON
Activated carbon canister parts to fill the cartridge air purifier filter used in MCH13-16-36 compressors.
BLACK WEIGHT POCKET 2.3 KG UNIT
High resistance cordura weight pocket for harness, with capacity for 2.3 kg ballast pads approximately. Fast closing and release clip in plastic on the outside and flap with Velcro. Ideal to place on harness webbing, tank webbing and even on belts. Stainless steel eyelet at the bottom for water drainage and rear strap to adjust to bottle buckle or harness. Sold by the unit.
ACCESSORIES POCKET BLACK
Heavy duty cordura accessory holder pocket for harness or jacket, perfect for carrying small accessories and even a spare mask . Ideal to place on harness webbing, jacket and even on belts with webbing up to 50 mm.
SEIKA GPS SYSTEM FOR SUEX DPV
Suex brought the GPS signal underwater in wireless mode - SEIKA transmits the position to all ERON D-1s in the water. SEIKA uses an embedded GNSS (Global Navigation Satellite System) receiver within an SMB (Surface Marker Buoy) to capture precise diver position and communicate wireless that position to the Suex Eron D-1 dashboard.
INT VALVE WO/PURGE FOR MCH6 COMPRESSOR
Load valve without purging and INT connection, valid for compressors Coltri MCH 6 portable.
XTREM KANGAROO SMALL HANDBAG
The TDS Xtrem Kangaroo pocket is a pocket specially designed for technical diving, being valid for both backmount and sidemount systems thanks to the versatility of its design. A pocket designed to the smallest detail to offer maximum performance to the technical diver.
DIN VALVE W/PURGUE FOR MCH 13/16 COMPRESSOR
Load valve purge stop valve and connection DIN 200 valid for compressors Coltri MCH 13/16 series.
TRIM WEIGHT POCKET
INT VALVE W/PURGE FOR MCH 13/16 COMPRESSOR
Load valve purge stop valve and connection INT valid for compressors Coltri MCH 13/16 series.
ARMADILLO BACK PAD
BACK PLATE POCKET
Designed for placing a buoy or a lifting bag between the backplate and diver´s back. Stainless-steel screws for attaching the pocket to the backplate are included.